Skip to content

Bluetooth dynamometers: measuring human strength

A dynamometer is a device that measures force. In sport and healthcare it means measuring human strength: how hard a person can pull, push or grip. This page explains the main types, what a Bluetooth dynamometer adds, and how to read the specifications. If you are looking for an engine or chassis dyno, this is not that kind of dynamometer.

Types of dynamometer for human strength

  • Hand-grip dynamometers measure how hard you squeeze a handle. They are common in clinics and in general health screening.
  • Handheld (push) dynamometers are pressed against a limb by the tester, who resists the patient’s push. The result depends partly on the tester’s own strength and technique.
  • Inline (pull or tension) dynamometers sit between an anchor and a handle, strap, edge or bar, and measure the pulling force through them. The Tindeq Progressor is this type.
  • Force plates are platforms you stand or jump on. They measure ground reaction force and are mostly found in labs and high-performance centres.

What Bluetooth adds

A dial or display dynamometer gives you one number, usually the peak. A Bluetooth dynamometer streams the whole force curve to a phone or tablet while the test is running. That means you can:

  • see force live, which helps you hold a target load or pace an effort;
  • save every test and compare sessions over weeks and months;
  • run timed protocols such as repeaters or endurance holds and let the app do the timing;
  • export raw data for your own analysis. The Progressor’s Bluetooth API is open, so you can log data in Python or your own software.

How to read the specifications

  • Design load / full scale: the largest force the device is built to measure. The Progressor 200 is 2000 N (200 kg); the Progressor 500 is 5000 N (500 kg).
  • Precision (% of full scale): the error band as a share of the full range. 0.25% of full scale is 0.5 kg on a 200 kg device and 1.25 kg on a 500 kg device, so a smaller range measures small forces more finely.
  • Sampling frequency: how many readings per second. Both Progressor models sample at 80 Hz, which is 80 readings every second.
  • Safe and limit overload: how far past full scale you can go without damaging the device (safe) or before it may fail (limit). Stay below the safe overload. For the Progressor 200 these are 120% and 150% of full scale; for the Progressor 500, 120% and 140%.
  • Non-linearity, repeatability, hysteresis: how consistently the reading follows the real force across the range, from one pull to the next, and between loading and unloading.

Who uses a Bluetooth dynamometer

  • Climbers test and train finger strength on an edge, and track progress with repeaters, critical force and endurance tests.
  • Physiotherapists measure strength in rehab, compare left and right sides, and show patients their progress.
  • Strength and conditioning coaches run isometric tests such as the mid-thigh pull and monitor athletes over a season.
  • Researchers collect raw force data. The Progressor has been the subject of published validity and reliability studies, listed on our research page.

Choosing between the Progressor 200 and 500

Both are inline Bluetooth dynamometers with the same app, sampling rate and precision class. The Progressor 200 covers forces up to 200 kg and suits finger, grip and single-limb tests. The Progressor 500 goes to 500 kg for whole-body and lower-limb tests. See the full comparison: Progressor 200 vs 500.

Frequently asked questions

Is a dynamometer the same as a force gauge?

For practical purposes, yes. Both measure force. “Dynamometer” is the usual word in healthcare and research, while climbers often say “force gauge”.

Do I pair it in my phone’s Bluetooth settings?

No. With the Progressor you turn on Bluetooth, wake the device with its button and connect from inside the free app. The user manual has the steps.